Canberra Car Detailing

Mach1 Car Detailing Specialists is a dedicated Car Detailing company. Pretty much if you scratch it and want it to be pristine again you have no option but to get the original detailer to redo the entire panel which involves removing the old ceramic layer (which might be up to around 6 microns), correcting the scratches and then re-coating it again.
Once the coating is applied, it requires 12-24 hrs of curing time. Also it would be better if you buy a mat that easy to clean, because paint protection film you will have to clean these mats from time to time than it is to have to sweep and mop your whole ceramic tile floor more regularly.

There has been lots of good advice about properly pre-rinsing a car, and using quality wash-mits and two bucket methods of avoiding as much as possible rubbing grit and dirt into your paint: coated or not, it will create fine scratches known as swirl marks that will need polishing to remove.
As an example, my Polo last year (two coats of Ceramic Pro) had a replacement windscreen and the mere wiping process of the technician's rags on the surrounding paintwork was enough to scratch it to the point where there was no point trying to remove the scratches as I would not have been left with sufficient clear coat left to make such a correction "safe".
Vonsternberk should have mentioned it if he has experience.I personally do not use either Opticoat or ceramic pro and not affiliated with either but I just don't see the point in bagging both products because they are both good, definitely not rubbish.

My Corolla, for example had some bits that were quite dodgy at around 90 microns but for the most part it was around 120 - 130 microns - a figure which I would say is pretty much an overall "average" for mass produced cars (incidentally, you pay all those dollars for a Lexus but the painting process is the same as my $22,000 Corolla).
Most ceramic coating companies have a milder prosumer” version of their flagship coating that they offer to DIY detailers. I would love for there to be a scratchproof coating but one simply does not exist and more than likely will never exist in my lifetime unless they stop painting cars and finish them using some other means.

No, We take care of cleaning the vehicle, decontaminating and preparing the paint work before we apply the Ceramic Pro Paint Protection. Other factors that affect the cost include the type of detailing required before the ceramic coating is applied to ensure the coating performs at its best, and how many layers of ceramic coating you apply to the vehicle.
Obsession Car Detailing in Canberra have produced some stunning work, they would be well worth a call. Im not a car detailer and dont profess to be but you come across as someone who may know something about it but then post silly comments about your washing procedure.
We are the car cleaning professionals. This step is especially important as this is when the nano ceramic coating forms crosslinks and becomes the protective coating for cars you need. Secondly, these touchless washes tend to use chemicals that will adhere to the coating reducing it's effectiveness and building up over time.

In order to maintain your warranty, every 6 months your car is due for an inspection and minor detailing service. No, Unlike other Paint Protection products on the market Ceramic Pro forms a permanent bond to the factory paint work and is resistant to heavy chemical cleaners so you are free to use any car wash shampoo you like.
Some of these include car detailing, car window tinting, and car ceramic coating in Canberra. Polish and wax aren't necessary every time but will keep the car in good condition if done properly. Tourmaline is a coating added to plates to improve styling. We also practise what we preach and offer professional car detailing at our locations, so we're happy to provide you with expert advice, help and support.

Leave a Reply

Your email address will not be published. Required fields are marked *